Ever wondered how a computer works? This is how it does. When computers were first invented, no one knew a thing about them except the inventor of the computers. It is good to realize that with time the technological advancement has become noticeable. People are now able to come up with new power supply models that are used in the computer. When you look at a computer, one cannot tell how it has been designed or what makes the computer to function. This text will try and shed some light on the hp computer power supply. In the hp computer, there is something that is known as the power supply unit. The power supply is the one that converts the energy that comes to the computer into the DC which is a regulated low voltage power. This is done because the internal components of the computer are quite delicate and the normal voltage might destroy them. Most of the desktops, hp included have their power supplies conformed to the ATX specification. The ATX power supply will always be connected to the power supply and then it provides 5 standby voltages which enable the computer to perform some of its tasks like shutting down. The ATX also send signals to the motherboard so that the computer can start up safely or shut down safely.
HP computer power supply has a lot of functions namely: It helps to change the source of energy from the voltage it has to low voltage. When electricity comes directly from a main source, it usually has some voltage which might be correct but are not useful to the hp computer. To ensure that there is stable operation of the computer, a number of direct current voltages are required. A voltage rail is the term that is used to refer to the single voltage that is produced by the power supply. They help reduce short circuit, overload, over current, under voltage, over voltage and even over temperature protection. The power supply as stated above has the ability to convert any amount of power that comes to the computer to 5 standby volts and so it prevents it from crushing. There are some areas that are very hot and as we know, the hp computer software does not require high temperatures and since it has been fitted with the power supply, it will not be spoiled. Overload affects the computer in that the computer software gets so heated up when there is over use of the computer and this power supply unit helps to convert it to the required standby volts. Under voltage can be corrected by the power supply because, the hp computer power supply has power factor correction device which increases that power supply by putting a coil in series with the filter capacitors.
The life span of the hp computer power supply is normally rated by the mean time between failures. Mean time between failures is the time that can be predicted between subsequent failures of a system while it is functioning. It can be done arithmetically. The lifespan of the power supply can be increased by the quality construction of the electrical components or a speed fan can help to maintain a high mean time between failures rating. This helps to keep the important components of the computer cool. To make sure that the power supply works efficiently, there is the need to ensure that the power supply is matched to the requirements of the computer. If your computer is used more often, you have to upgrade your power supply. You should also try to have a more efficient hp power supply unit so as to prevent the emission of the green house gases. So go on ahead and upgrade your hp computer power supply works efficiently when upgraded.
New! Comments
Have your say about what you just read! Leave a comment in the box below.